Installation & Assembly

53
Anchor-It
Anchor-It
Strap
5/16 x 1-1/2”
Lag Screw
5/16”
Washer
5/16 x 1-1/2” Lag Screw (x4)
Fold up
ANCHOR-ITS
3ODFHVZLQJVHWLQ¿QDOORFDWLRQDQGPRXQW$QFKRU,WVDWORFDWLRQVFLUFOHGDERYH
2. Twist the Anchor-It into the ground until only the loop is exposed.
3. Place Anchor-It Strap thru loop, fold the ends together and attach to the unit as shown.
Note: Keep as little play as possible using any of the holes in the strap that work best.
TIP: When installing Anchor-Its in rocky or hard soil, create a starter hole at the desired locations using
either a 16’’ Concrete Drill Bit, or a long screw driver then insert and install the Anchor-Its as shown. This
will allow you to get traction with the Anchor-It faster and allow the device to seat more securely.
x4 x4