Instructions / Assembly

HOW TO BUILD YOUR SWING SET

ASSEMBLING THE A-FRAME

1. Measure the two 4”x4”x8’ beams to ensure that they

are the same length, adjusting as needed. Lay the two

beams on a level surface and slide the top ends into

the leg openings on the A-frame bracket. These are

the two shorter openings.

2. Secure the bracket to the beams using 4 lag bolts and

washers for each beam. Drive the bolts through the

beam, 2 on each side of each beam. (Pre-drilling holes

smaller than the bolts before screwing the bolts in may

allow easier securing with less risk of splintering the

wood.)

3. Repeat steps 1 and 2 for the other bracket, so you

now have two V-shaped leg frames.

In order to build this swing set you must purchase wooden beams. The A-frame brackets are

designed to be used with a 4x6 top beam and 4x4 support beams. To build the swing set

8ft depth and 7.8ft height.

Before building this swing set, check that you have a minimum space of 24ft by 20ft,

to ensure at least 6ft of space on each side of the set.

PAGE 9

Before starting assembly, check that you have all necessary parts. If any

parts are missing or damaged on delivery, please contact Swingan

customer support directly on 1-800-574-9323 for immediate replacement.