Operating Guide

TRANSMITTER AND RECEIVER
The grader comes equipped with a remote control to raise and lower
the unit by electric actuator. The remote has two buttons, one to
extend and one to retract the actuator. Follow the directions
below to activate the remote once battery is installed.
1) Once receiver is plugged into a power source, with the
remote in hand hold down the button on the receiver box
until a GREEN LED light comes on solid.
2) Once the GREEN LED is solid hold down one of the buttons
on the remote for approximately one second and verify the
GREEN LED light flashes momentarily when button is
pressed.
3) Repeat this process but with the opposite button on the
remote
4) Once both signals have been sent to the receiver the LED
light on the receiver should turn solid RED. This means
your transmitter and receiver are now paired.
5) Press the IN and OUT button as needed.
To turn off the wireless system press the button on the receiver box
once and ensure there is no longer a LED light on.
LED Indicator Light
Steady RED – The system is active and ready to use.
Flashing RED during use – The battery or power source is low.
RED light is off – The wireless remote control is turned off, or not
active.
Replacing batteries
If the indicator light on the handheld remote
f
lashes during use, the batteries are
low and should be replaced.
1) Remove the two screws from the
handheld remote located on the back
of the remote.
2) Separate the top and bottom sections
of the remote using a flat head screw
driver or similar device.
3) Remove the old batteries and dispose
in accordance with local
environmental regulations.
4) Insert (2) new A23 style alkaline
batteries as shown with the positive
terminals facing the switches. Do not
mix old and new batteries.
5) Join the top and bottom sections
making sure they snap together and
rubber seal remains intact.
6) Secure with the two screws.
Battery Location
Sc
rews
OUT
IN
6