Use and Care Manual

絆

FIGURE 10.1

JACKSTAND & COUPLER See Figure 10.1

1. Assemble the Jackstand 19 to the Hitch Tube 14

using (2) U Bolts 10 , (2) Support Plates 20 , (4) 3/8”

Washers 7 and (4) 3/8” Nyloc Nuts 5 .

2. Assemble the Ball Coupler 22 to the Hitch Tube 14

using (1) 3/8” X 3 Bolt 6 , (1) 3/8” X 3-1/2 Bolt 8 , (4)

3/8” Washers 7 , (2) Safety Chains 12 and (2) 3/8”

Nyloc Nuts 5 . Note the order of the parts in the

diagram.

3. With assistance from another person, carefully roll the

hopper assembly 180° until it is upright.

See Figure 10.2

FIGURE 10.2

Note: The Item Numbers

on this page refer to the

table on page 7

ASSEMBLY DIRECTIONS