Use and Care Manual

Bombardier Outlander

Accessory Mount Brackets Kit #7668

ACCESSORY MOUNT

WELDMENT

3/8 SAE WASHER

5/16 SAE WASHER

3/8 NYLOC NUT

5/16 NYLOC NUT

ACCESSORY MOUNT

BRACKET

3/8 X 2 ½ BOLT

5/16 X 2 BOLT

HARDWARE AND PARTS

2 - ACCESSORY MOUNT BRACKET 7669TK

2 - ACCESSORY MOUNT WELDMENT 7670TK

4 - 3/8-16 X 2 ½ BOLT NB619

8 - 3/8 SAE WASHER NB272

4 - 3/8 - 16 NYLOC NUT NB182

2 - 5/16 - 18 X 2 BOLT NB507

2 - 5/16 -18 NYLOC NUT NB181

4 - 5/16 SAE WASHER NB275

MOUNTING INSTRUCTIONS

(REFERENCE FIGURE ABOVE, LEFT SIDE SHOWN)

RAISE ATV SO THERE IS ENOUGH ROOM TO WORK. MAKE SURE THE SUPPORT

USED TO HOLD UP THE ATV IS VERY STABLE. LAY OUT THE PARTS AND HARDWARE UNDER THE ATV.

MOUNT THE BRACKET AND WELDMENT AS SHOWN IN THE FIGURE. REPEAT THE SAME PROCESS FOR THE

RIGHT SIDE.

REMOVE THE EXISTING 5/16 CENTER BOLT FROM THE A-ARM / WHEEL ASSEMBLY. DO NOT REMOVE ANY

OTHER BOLTS FROM THE ASSEMBLY.

COMPLETE THE INSTALLATION OF THE ACCESSORY MOUNT USING THE INSTRUCTIONS ON PAGE 5 OF THIS

MANUAL.

Bombardier TraxterMax Extension Kit

Part # 2900 (Optional)

Note:

Extension of 21 – 33 inches at

Six inch increments.

NB577 (2 Needed)

NB177 ( 4 Needed)

NB281 (2 Needed)

2697TK