Use and Care Guide

Pivot Latch Assembly
Part of Pivot Weldment 2323
has been hidden for clarity.
The tail of Pivot
Spring 2336 must
be inserted into loop.
5
These steps need to be done in sequence:
1. Lay parts down in the order they are shown below.
2. Slide Plow Mount 2588 (29) into Pivot Weldment 2323 (23) and secure with ½-13 X 3½ Bolt
NB577 (30) and ½-13 Nyloc Nut NB281 (20). Do not overtighten; the Plow Mount must be
able to pivot freely.
3. Assemble the Pivot Latch assembly in the order shown below. The Pivot Latch assembly
consists of the following components and is assembled in the following order: ½-13 X 3½
Bolt NB577 (30), Plow Mount 2588 (29), ½ Washer NB177 (19), Lever Latch 2840 (26), ½
Washer NB177 (19), ½-13 Lock Nut NB121 (22), Pivot Spring 2336 (25), 1½ Washer
TR150W (24), and Lock Nut NB121 (22). Make sure the tail of the pivot spring is secured
into the bent metal loop on the Plow Mount. Do not overtighten; the Lever Latch should be
able to pivot freely after being assembled.
4. Attach Plow Support Bracket 2310 (27) and Lift Bracket 2841 (34) to Plow Mount 2588 (29)
as shown using two NB150 3/8-16 X 3 Bolts (28) and two NB182 3/8-16 Nyloc Nuts (4).
5. Insert ½-13 X 3 Bolt NB131 (33) into Lift Bracket 2841 (34) and secure with ½-13 Nyloc Nut
NB281 (20). Do not overtighten as this can bend the Lift Bracket. This is where you will
attach your winch or manual lift pulley, sold separately.
TO ENSURE PROPER ASSEMBLY, CAREFULLY
FOLLOW ALL INSTRUCTIONS LISTED BELOW
The numbers in parenthesis
on this page refer to items
from the table on page 4.