Use and Care Manual

TO ENSURE PROPER ASSEMBLY AND
INSTALLATION, CAREFULLY
FOLLOW ALL INSTRUCTIONS LISTED BELOW
REFER TO FIGURES 2 AND 3 WHILE ASSEMBLING AND INSTALLING THIS PORTION OF THE
PLOW ATTACHMENT
The next steps need to be done in sequence:
1. Lay parts down in the order they are shown below.
2. Slide the plow mount (1) into pivot weldment (2), secure with ½-13 X 3 1/2 bolt (34) and ½-13 nyloc nut (8).
3. Assemble the Pivot Latch assembly in the order shown below. The Pivot Latch assembly consists of the
following components - lock arm (23), two bushing (32), two ½-13 lock nut (33), Washer (21), pivot spring (26)
and ½-13 X 3½ bolt (34) to plow mount (1). Make sure the tail of the pivot spring is secured into the bent metal
loop on the plow mount. See Figure 3 below. Note, the lock arm should be able to pivot freely after being
assembled.
4. Bolt plow mount bracket (24) and plow bracket support (25) to plow mount (1), as shown, using two 3/8-16 X 3
bolts (10) and two 3/8-16 nyloc nuts (12).
5. Insert ½-13 X 3 bolt (9) into plow mount bracket (24) and secure with ½-13 nyloc nut (8). Do not over tighten as
this can bend the plow mount bracket. This is where you will attach your winch or manual lift pulley, sold
separately.
6. With your Swisher ATV Accessory Mount already installed, attach the plow using plow mount pin (6) and two
3/16 click pins (7).
7. Read Dangers on the back of the Swisher Plow and consult this manual.
8. It would be wise to become familiar with your plow using a slower speed.
9. Operating instructions are on page 7.
Figure 3
6
23
34
32
33
21
26
Top of weldment is removed for clarity.
1
2
24
Tail of Spring 26
23