swisherinc.com OWNER’S MANUAL MODEL NO. LSEK14534 LSEK14534-CA STARTING SERIAL #: L114-196001 IMPORTANT Read and follow all Safety Precautions and Instructions before operating this equipment.
LIMITED WARRANTY The manufacturer’s warranty to the original consumer purchaser is: This product is free from defects in materials and workmanship for the period's shown below beginning from the date of purchase by the original consumer purchaser. We will repair or replace, at our discretion, parts found to be defective due to materials or workmanship.
SAFETY PRECAUTIONS This Safety Alert Symbol indicates important messages in this manual. When you see this symbol, carefully read the message that follows and be alert to the possibility of personal injury. Read this manual completely. This machine can amputate hands, feet, and throw objects. Failure to observe the following safety instructions could result in serious injury or death.
• NEVER operate your splitter near a flame or spark. Hydraulic oil and gasoline are flammable and can explode. • NEVER fill gas tank while the engine is hot or running. Allow the engine to cool before refueling. • This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-covered, brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any).
TOWING SAFETY • Do not allow persons to ride on splitter. Do not carry any cargo or wood on your splitter. It may fall off and endanger vehicles that are following you. • Be sure support leg is in the travel position and coupling secure. This must also be retracted so as not to interfere while towing. Retract support leg by removing pin, pivoting up, and replacing pin. • Never exceed 45 MPH while towing your splitter. Be extra cautious when traveling over rough terrain, especially over railroad tracks.
ASSEMBLY This log splitter has been partially assembled at the factory. Refer to the drawings and part lists should it become necessary to disassemble the unit for repair or replacement of parts. Inspect all components for damage. If you believe you have a damaged part please contact customer service immediately at 1-800-222-8183. WARNING: Exercise extreme caution, as parts are very heavy. Sufficient persons or mechanical handling equipment should be used.
COLD WEATHER START UP The Cold Weather Clutch enables the engine to be started without having to pull through cold, thickened hydraulic fluid. Simply push the handle in to the locked position. Start engine, let it warm up, and pull out the Cold Weather Clutch handle to engage pump system.
*Fluid escaping from a very small hole can almost be invisible. Do not check for leaks with your hand. Escaping fluid under pressure can have sufficient force to penetrate skin causing serious personal injury or even death. Leaks can be detected by passing a piece of cardboard or wood over the suspected leak and looking for discoloration. IF injured by escaping fluid, see a doctor at once. Serious infection or reaction can develop if proper medical treatment is not administered immediately.
SAFETY DECALS Replace decals immediately if damaged.
ASSEMBLY DETAIL IDLER DETAIL ASSEMBLY DETAIL Item # 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 NOT SHOWN NOT SHOWN Part # 7296K NB179 2203CN NB633 2203DC NB151 NB555 NB688 18839TK NB587 2030 19177TK NB182 12441 NB272 12363 19165 Description Tire/Wheel, Log Splitter; Blk Item # Washer - 3/4 ID X 1 1/4 OD 18 GA ZY 1 Nut - Castle 3/4-16, .
FILTER DETAIL FILTER DETAIL Item # 1 2 3 Part # LS1112 LS1113 7329 Description Head - Filter (FPC3012NXXR4X) Filter - Element Fitting - Line Return (4501-12-12) YZ BELT ROUTING DIAGRAM (VIEWED FROM UNDERSIDE OF LOG SPLITTER) IDLER PULLEY PUMP DETAIL PUMP PULLEY BELT PART # 19198 ENGINE PULLEY PUMP DETAIL Item # 1 2 3 4 5 6 7 8 9 10 11 12 11 Part # 19163 NB596 9030 NB182 19167TK NB170 19166 NB618 19175 LS4999 19171 NB312 Description Pulley - Pump 5/8" ID x 4" OD Bolt - Serr Flange, 5/16-18 X 3/4
BEAM DETAIL BEAM DETAIL Item # 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 WEDGE DETAIL Part # 19581TK 7288TK 7291 7355TK 7293 NB642 7292 NB121 NB555 12669 7329 7287TK 19699 19578TK NB108 NB779 NB780 19579TK Description Weldment - Beam, LSEK14534; Txt Blk Line - Asy Stationary, Splitter; Txt Blk Elbow - Hydraulic (2501-8-8) YZ Cylinder - 5 X 24 X 2 Painted Pin - Cylinder to Beam Zp Cotter - Hairpin #23-09 .
TONGUE DETAIL TONGUE DETAIL Item # 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 FUEL DETAIL Item # 1 2 3 4 5 6 7 8 NOT SHOWN NOT SHOWN NOT SHOWN NOT SHOWN Part # 19565TK 18225 26X249 18214 18221 NB180 NB274 12379 18223 6FLC 11782 18232 Description Cover - Fuel tank, Txt Blk Bracket - Fuel Tank Screw - .312-18 X .75 Fuel Tank - 2.5 Gallon, Carb, W/O Cap Cap, Fuel - 2.
ENGINE DETAIL ENGINE DETAIL Item # Part # 1 N/A 2 NB711 3 NB618 4 689S 5 19164 6 9031 7 689L 8 10291 9 NB452N 10 19181 11 26X249 12 TR150W NOT SHOWN 16000 NOT SHOWN 18810 NOT SHOWN 7414 NOT SHOWN N/A NOT SHOWN N/A NOT SHOWN N/A BEAM LATCH DETAIL ITEM # 1 2 3 4 QTY. 1 1 1 1 PART # 18821 18822 18823 NB126 DESCRIPTION PIN - BEAM LATCH SPRING - COMPRESSION WASHER - FLAT, 1/2" SAE PIN - COTTER 14 Description Engine - KAW 14.
12 VOLT ACCESORIES Item # 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 NOT SHOWN NOT SHOWN NOT SHOWN NOT SHOWN NOT SHOWN NOT SHOWN Part # 19566TK 19569TK 19567TK 19568TK 26X249 024206 NB161 1002004 19170 9087 9088 NB711 NB456 3623 26X263 686K 19169 19691TK NB524 NB690 AS013 NB180 26X229 NB274 NB180 NB551 BATPAD AS084 19187 BC24 BCBT BCS BCSR Description Plate - Right Side, Console; Txt Blk Plate - Rear, Console; Txt Blk Plate - Left Side, Console; Txt Blk Plate - Top, Console; T
TROUBLESHOOTING Problem Engine fails to start. Cause 1. Spark plug wire disconnected. Remedy 1. Connect wire to spark plug. 2. Fuel tank not full enough or stale fuel. 2. Fill tank full with clean, fresh gasoline. 3. Throttle control lever not in correct 3. Move throttle lever to FAST position. starting position. 4. Fuel valve not ON or blocked fuel line. 4. Turn on fuel valve or clean fuel line. 5. Faulty spark plug. Engine is hard to start or runs erratically. 1. Spark plug wire loose. 2.
MAINTENANCE LOG Date of Service Service Performed 17 Notes
SPECIFICATIONS Splitting Force 34 Tons* Engine 14.5 HP Kawasaki, 603CC Battery 12V Type U1L (not included) Splitting Positions Horizontal and Vertical Cylinder Size 5" X 24" Pump 2 Stage with Heavy Duty Bearings Pump Specs 22 Gallons Per Minute Valve Auto Return Drive System Belt Drive 1:1 Ratio with Clutch for Easy Starting Hydraulic System Fluid Capacity 54-56 Quarts(13.5-14 Gallons) Maximum Log Length 25 1/2" Tire Specs 4.00 X 4.
SWISHER HISTORY Back before electricity came to rural Missouri Max Swisher was producing lawn mowers from his mother’s chicken house. Max never liked to mow grass. He installed a gearbox on his family’s lawn mower creating a self-propelled unit. By tying one end of a rope to the mower and the other end to a tree in the center of the yard the mower circled the tree, shortening the rope and guiding the mower in concentric circles. Max enjoyed relaxing under a shade tree while his invention did all the work.
LOG SPLITTER swisherinc.com OWNER’S MANUAL MODEL NO. LSEK14534 HOW TO ORDER REPAIR PARTS: Each Log Splitter has its own serial number. Each engine has its own serial number. The serial number for the Log Splitter will be found on the right hand side of the hydraulic oil reservoir. The serial number for the engine will be found on the top of the blower fan housing. All Log Splitter parts listed herein may be ordered directly from Swisher, your nearest Swisher dealer, or from our website.