Replacement Part List

15. At this point it is suggested that you
determine how the door will be brought
into the Safety Shelter. If clear access
can be gained on either side then leave
the panel for that side out until after the
door is installed. If clear access is not
available to either side or back of the
Safety Shelter, the door can later be
brought in through the door opening. It is
just much easier to bring it in through
one of the sides or the back.
16. Emergency Exit Lower and Upper Wall
Section Assembly – The Emergency Exit
Wall Sections must not be located where
there is an obstruction or wall blocking
your exit from the shelter through this
wall when removed. You do have the
flexibility to place it in either of the Side
Walls or the Back Wall. It cannot be
placed in the front wall. Note: In Model #
SR84X039G one of these sections can
only be placed on a side wall. When
assembling these panels, Gussets must
be installed along the inside edge of
each vertical wall section rib (as seen at
left), two per wall panel section. Note
that the two inner most bolts holes are
used on the center rib. The outside ribs
do not require these bolts. See Page 12
for the appropriate size bolts and nuts for
this assembly. Tighten all nuts to 31 Ft-
lbs torque.
25
3/8-16 X 1
Carriage Bolt 19828
3/8-16 X 1 1/4
Carriage Bolt 19829