Replacement Part List

33. Tighten all bolts in every wall flange to 31
Ft-lbs.
32. Tighten all bolts around the roof exterior
and interior flanges to 31 Ft-lbs.
31. Install all the remaining anchor bolts
around the bottom flange of the entire
Safety Shelter. Once installed, make
sure to torque them to 40 Ft-lbs. See
instruction in Step 5 of this manual and
follow the Manufacturers Instructions. If
needed a steel punch or large screw
driver can be used to help align the holes
in the base flanges with the holes in the
concrete.
It is ok to install the four anchor bolts at
the base of the Front Wall. However,
after you torque them down, remove the
nuts and washers. In a later Step these
will be reinstalled.
31