Installation Guide

4
22121 REV 19
-
335
Installing Anchors:
• Before installing anchors, the dust needs to be removed from the drilled holes to ensure
proper anchoring; this can be done by blowing them out with air or a vacuum. Set
shelter in place as directed in the ESP Safety Shelter Assembly Instructions and verify
anchor hole alignment. Start the anchor nut on the top of threaded anchor and then
tap anchor in hole with a hammer to maximum depth. Hand tighten top nut and then
using a torque wrench, torque the anchor bolts to 40 Foot Pounds to expand bottom
wedge. Do not over tighten anchor. If the anchor begins to spin, the anchor will not
work properly and you should consult a professional in anchor installation for alternate
solutions.
Precautions:
• Failure to follow the above recommended guidelines could result in an improper
Safety Shelter installation. An improperly installed Safety Shelter will not provide the
level of Safety and Security your ESP Safety Shelter was engineered and designed to
provide.