Use and Care Guide

6. Install 8 Vents (PN 19775), two vents in
each corner section. Vents should be
installed from the outside the tabs should
be bent to the inside.
5. To the left is a view of the proper anchor
bolt installation. The embedment length
of 2” is critical to the safe function of the
Safety Shelter.
Note: The minimum thickness of
concrete is 5” as long as appropriate
overhang outside the Safety Shelter
exists on all four sides (see chart on
Page 19 for your shelter model).
When drilling holes in concrete a
Carbide Bit MUST BE used, DO NOT
use a Diamond Bit.
4. Following the manufacturers instructions,
install the 3 anchor bolts (PN 19790) in
the front left corner (Door Jamb Corner)
to the proper depth in the concrete (see
next step). At this time leave the washer
and nut on the bolts to protect the
threads.
Mark depth on Drill Bit to 2.75”-3.00”.
Be sure NOT to drill through concrete.
Template shown for illustrations purposes only. It
must be removed prior to installing any anchor
bolts.
Inside View
Outside View
22