Installation Guide

IMPORTANT

Carefully study exploded view and steps before assembly. leave

all hardware loose until instructed to tighten. When assembling, a

ÀDWVXUIDFHZLOOEHKHOSIXO

1. Starting from the edge of one top panel, slide

divider strip on to panel.

2. Center divider strip on panel.

3. Slide other top panel into divider strip.

Page 4 of 6

STEP 1

Panel

Divider Strip

STEP 2

1. Attach two (2) bows to panels using four (4) 1/4 x

3/4 bolts and lock nuts.

2. On model XLR-52 attach four (4) bow extenders to

panel and bow ends using four (4) 1/4 x 1 bolts and

lock nuts.

Bow Extender

Bow

STEP 3

1. Install edge channels to edge of panels.

2. Attach edge channels to bows or bow extenders

using four (4) 1/4 x 3/4 bolts and lock nuts.

2162_026.JPG

2126_054.JPG

2126_020.JPG

PAGE 1
IMPORTANT Carefully study exploded view and steps before assembly. leave all hardware loose until instructed to tighten. When assembling, a ÀDW VXUIDFH ZLOO EH KHOSIXO STEP 1 1. Starting from the edge of one top panel, slide divider strip on to panel. 2. Center divider strip on panel. Panel Divider Strip 2162_026.JPG 3. Slide other top panel into divider strip. STEP 2 1. Attach two (2) bows to panels using four (4) 1/4 x 3/4 bolts and lock nuts. Bow Extender Bow 2126_054.JPG 2.
PAGE 2
STEP 4 2162_012.JPG 1. Install rubber bumpers to front and back of left and right struts. STEP 5 1. Remove nuts from bows and attach left and right VWUXWV ZLWK ZLGH ÀDQJH IDFLQJ RXW 2126_009.JPG 2126_054.JPG 2. Tighten all bolts. STEP 6 1. For straight up and rear leaning roll bars insert two (2) 3/8 x 1 bolts in holes (A) with head of bolt against weld nut. B A 2. For forward leaning roll bars use holes (B) B A 2126_016.JPG 3. Repeat procedure for other strut and tighten bolts. STEP 7 1.
PAGE 3
STEP 8 1. Lay roll bar bracket on top of roll bar with adjustment teeth towards rear. 2126_031.JPG 2. Attach L-Clamp to roll bar bracket using two (2) 3/8 x 2 bolts and lock nuts on rear top and two (2) 3/8 x 1 1/4 bolts and lock nuts on front bottom. 3. Center bracket assembly on roll bar and tighten bolts. STEP 9 1. Mount assembled TuffTop to roll bar bracket by sliding front bolts into slots (A). A B 3. Slide lock forward over front bolts. 4. Attach four (4) clamp knobs to bolts and tighten.