Use and Care Manual

Operator Presence System:
Be sure to check that the operator presence and interlock systems are working properly before each use. If your
mower does not function as described, repair the problem immediately.
The engine should not start unless the drive pedal is disengaged, the blade lever is disengaged
(forward) and the operator is in the seat.
– See OPERATION FEATURES section of this manual.
When the engine is running any attempt by the operator to leave the seat will cause the engine to shut off,
regardless of the blades being engaged.
When the engine is running and the blades are engaged any attempt by the operator to mow in a generally
rearward direction will shut off the engine unless the key is first turned to the “mow in reverse” position.
– See OPERATION FEATURES section of this manual.
Tires:
Maintain proper air pressure in all tires (SEE SPECIFICATIONS section).
Keep tires free of gasoline, oil or insect control chemicals which can harm rubber.
Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage.
Blade Maintenance:
For best results, mower blades must be kept sharp.
Replace bent or damage blades.
Safely raise front of mower and place on secure jack stands.
Hold or block blade from turning.
Loosen blade bolt and remove blade.
Replace blade (SEE SPECIFICATIONS).
Battery:
To clean battery and terminals
Remove the BLACK terminal guard.
Disconnect the BLACK battery cable and locate it where it
cannot come into contact with the battery.
Remove the RED terminal guard.
Disconnect the RED battery cable and locate it where it
cannot come into contact with the battery.
Remove the battery.
Rinse the battery with plain water and dry.
Clean terminals and battery cable ends with wire brush
until shiny.
Coat terminals with Dielectric Grease or Petroleum Jelly.
(This helps seal and prevent corrosion.)
Reinstall battery.
Reconnect the battery cables. Attach the RED cable first
then the BLACK cable.
WARNING
When it is necessary to raise the mower
for any repair or service, use jackstands
to provide adequate support. DO NOT
rely on hydraulic or mechanical jacks.
CAUTION
Stop engine, disengage drive pedal, and
remove ignition key for safety.
Disconnect spark plug wire. Wear heavy,
thick gloves when holding onto blade.
Avoid the sharp edge of the blade.
CUSTOMER RESPONSIBILITIES
10
10
WARNING
The battery contains sulfuric acid and
electrolytes which are poisonous and
corrosive.