Use and Care Manual

CUSTOMER RESPONSIBILITIES
V-Belts:
Check V-belts for deterioration and wear before each use and replace if necessary. Replace belts if they begin to
slip from wear. SEE SPECIFICATION for belt part numbers and SERVICE section of this manual for instructions
on how to replace the belt.
Engine:
REFER TO YOUR ENGINE OWNERS MANUAL.
Overall Unit Care:
Reduce the risk of fire by removing grass, leaves and other debris that may have accumulated on the machine.
Allow the machine time to cool before cleaning or putting it in storage.
Wash mower periodically. Clean above and below deck.
Keep all electrical connections clean and tight.
Driving & Transport on Public Roads:
Check applicable road traffic regulations before driving and transporting on public roads.
If the machine is transported, you should always use approved fastening equipment and ensure that the
machine is well anchored to the towing vehicle.
The cutting deck should also be lowered to the lowest position and the drive pedal disengaged during transport.
Left: 17 ½” High Lift Right: 15 ½” High LiftBLADES
FRONT: 4.10 / 3.50 – 5 REAR: 11 x 4.00 – 4 TIRE SIZE
Welded / 3/16” sheet metal; pivoting for deck adjustmentREAR AXLE
Hand operated crank styleDECK LIFT
Low back, Non-adjustableSEAT
90° worm gearbox, 10:1 ratioTRANSMISSION
Integrated into the disengage side of the drive pedalPARKING BRAKE
Approximately 1.5” – 5”CUTTING HEIGHT
32”DECK WIDTH
LENGTH: 57”
WIDTH: 41.5” (Including Grass Chute)
HEIGHT: 30.25”
WEIGHT: 340 lbs
UNIT MEASUREMENTS
35 ft. lbsBLADE BOLT TORQUE
12V / Lead Acid / Type 14A-A2BATTERY
FRONT: 50 psi Max REAR: 24 psi MaxTIRE PRESSURE
0 – 3 mphSPEED
SEE ENGINE MANUALSPARK PLUG
SEE ENGINE MANUALOIL TYPE (SPI-SF-SJ):
2 Qt. PLASTIC TANK; UNLEADED REGULARGASOLINE CAPACITY AND TYPE
12
12
Specifications