Use and Care Manual

Jackshaft Belt Routing & Replacement
For replacement belt part number refer to Replacement Parts Quick Reference Chart in this manual.
Removal
Disconnect spark plug wire.
Make sure machine is on level ground.
Jack up the front of the machine to gain access to the belt.
Release the tension from the idler.
Roll the belt over the top of the jackshaft pulley.
Replacement
Install new belt by placing it around the engine and jackshaft pulley. Refer to routing diagram below.
The belt will be loose at this time.
Tightly secure the belt tension back to its original position.
Check for sufficient tension on all belts.
Reconnect the spark plug.
SERVICE & ADJUSTMENTS
18
18
WARNING
When it is necessary to raise the mower for
any repair or service, use jack stands to
provide adequate support. DO NOT rely on
hydraulic or mechanical jacks.
1. Engine-to-Jackshaft belt
2. Engine pulley
3. Jackshaft pulley
4. Inside idler pulley
5. Tensioning spring
5
4
Rotation
1
2
3
Front of machine (bottom view)