Use and Care Manual

Drive Belt Routing & Replacement

For replacement belt part number refer to Replacement Parts Quick Reference Chart in this manual.

Removal

Disconnect spark plug wire.

Make sure machine is on level ground.

Remove hood.

Make sure the drive pedal is disengaged.

Remove belt from the drive and jackshaft pulleys.

If the belt tension is too tight to remove, one of the

pulleys may need to be removed as well.

Replacement

Install new belt by placing it around the jackshaft pulley first, then around the idler pulleys and drive

pulley. Refer to routing diagram below.

The belt will be loose once installed. This is by design.

Manually engage the drive pedal to make sure there is adequate belt tension.

The belt tension may need to be tightened or loosened using the pedal linkage rods.

Important: When the pedal is completely disengaged the brake pad should be fully engaging the

drive pulley.

Reinstall the hood.

Reconnect spark plug wire.

SERVICE & ADJUSTMENTS

1. Drive belt

2. Jackshaft pulley

3. Drive pulley

4. Inside idler pulley

5. Backside idler #1

6. Backside Idler #2

7. Brake Pad

Front of Unit (Top View)

Rotation