Use and Care Guide

彆
ȭ
A battery is not shipped from the factory with the these units. Batteries are classified by their physical size,
and individual size categories are given a "group number" by the Battery Council International. This Walk
Behind Trail Cutter was designed to use a U1 battery group size or smaller.
Use a 12-volt battery with a minimum of 230 cold cranking amps (CCA)
Be careful not to connect the battery in reverse polarity, as this will short circuit the battery charging system.
Always connect the positive (+) battery cable to the battery terminal before connecting the negative (-)
battery cable, so your tools cannot cause a short circuit if they touch a grounded part while tightening the
positive (+) battery cable end.
The battery positive (+) cable is connected to the starter solenoid terminal as shown. And the battery
negative (-) cable is connected to the engine mounting bolt at the factory.
1. Connect the RED battery positive (+) cable to the battery positive (+) terminal as shown.
2. Connect the BLACK battery negative (-) cable to the battery negative (-) terminal as shown.
A battery can explode if you do not follow the correct
procedure, seriously injuring anyone nearby.
Keep all sparks, open flames, and smoking materials away
from the battery.
BATTERY CONNECTIONS FOR ELECTRIC STARTER
(applicable models)
5