Installation Guide

— 1 —
If you have any questions or concerns please contact us:
1-434-623-4766
[e-mail]
PRIOR TO INSTALLATION:
· Inspect bidet to ensure no damages have occurred while in shipping.
· Observe all plumbing and building codes in accordance with your state and local requirements.
· All dimensions are nominal! Be sure to measure your bidet prior to installation.
· The step-by-step guidelines in the installation instructions are a general reference. Should there be
any discrepancies, Swiss Madison cannot be held liable. It is recommended to install all Swiss
Madison products by hiring a licensed professional.
· Read installation and maintenance instructions thoroughly before installing. Be sure to use proper
tools and always wear proper personal safety accessories for your protection.
· Two people are recommended to handle and install this product as it is fragile.
· Install in-wall carrier system (SM-WC124 - not included) prior to installing bidet.
· The Bidet cannot be installed on an outside exterior wall.
· A minimum 14" access panel behind the wall where the unit is mounted will be required for
installation and service.
· Separate shutoffs on hot and cold water lines should be installed. Please check with your local codes
to see if a mixing valve is required for your bidet installation to avoid scalding.
INCLUDED PARTS:
SUGGESTED TOOLS & MATERIALS:
Safety
Glasses
Wrench
Level
Screwdriver
Putty Knife
HacksawFlexible
Supply Tube
Tape
Measure
Mounting
Hardware
Bidet
WALL-HUNG BIDET INSTALLATION INSTRUCTIONS
Sealant