Installation Sheet

2. Mount Sink
· Put sink back in position and mark where to install mounting hardware.
— 5 —
TWO PIECE PEDESTAL SINK INSTALLATION INSTRUCTIONS
1. Drill two holes in the required position on the wall
using a14mm masonry drill bit, to a depth of 75mm.
3. Screw a fixing bolt into each fixing plug using a 8mm
spanner until the spanner contacts the wall.
2. Push a wall plug into each hole.
4. Place the basin in position against the wall. Locating
the fixing bolts through the holes in the rear of the basin.
Push a plastic washer followed by a metal washer, onto
each fixing bolt.
5. Screw a metal nut onto each fixing bolt to secure the basin.
Caution: Do not overtighten, as this may damage the ceramic.
NOTE: These fixings are suitable for solid walls only. Plasterboard or stud walls may require specialist fixings (not supplied).
CAUTION: Care should be taken when drilling walls and floors to avoid any concealed wires or pipes.
Plastic
Solenoid
Metal
Screw
Plastic
Gasket
Metal
Gasket
Metal
Nut