Installation Guide

Mark drain hole on oor. (All in oor plumbing must be installed by a licensed plumber)
SHOWER BASE INSTALLATION INSTRUCTIONS
1. Verify that the shower base is level using the “level” tool on all four sides.
• If the shower base is level proceed to step 2.
• If shower base
level use shims or mortar compound to adjust accordingly. Verify with “level
tool.”
2.
To ensure base is installed correctly,
entire bottom support must contact
Bottom Support
Bottom Support
Wall
Level
Square
Pre-attach Drain
WARNING: DO NOT discard cardboard ring.
2. Thread silicone or plumbers putty under drain lip, so when inserted excess sealant will squeeze out
3. Flip shower pan upside down: Add rubber ring then cardboard ring and lastly screw on the plastic
ring.
4. While holding the bottom of the shower drain in place with split-joint pliers, use shower wrench to
5. Use rubbing alcohol and a towel to remove all excess silicone/plumbers putty from around drain lip.
5