Installation Guide

Studs must be
ush and square
SHOWER BASE INSTALLATION INSTRUCTIONS
L
W
L
W
10”
10”
Rough-In
CAUTION: DO NOT use drywall screws to secure anges to wall studs. Product
damage will occur and will void the warranty.
Entire bottom support must be in contact with a at level surface.
1. Read the complete instruction manual before beginning installation.
2. Conrm that your model will t in intended location and plumbing xtures are
located where legally required before beginning installation.
3. Not all drawings on this manual are drawn to scale. Please refer to the model chart.
4. Walls and sub-oor must be solid, ush, and square.
5. Always use drop cloth to protect shower base from damage during installation.
6. Two people are recommended to install and move this product.
Roughing-in
• Rough plumbing must be pre-installed by a certied plumber before shower base
installation.
• If oor drain-hole installation is needed, contact a certied plumber.
10” x 10” Floor cut-out
Wall studs
 2 