Full Product Manual

— 3 —

3. Pre-Attach Drain

· Do not discard cardboard ring.

· Remove shower base from dry fit.

· Thread silicone or plumbers putty under drain lip, so when inserted excess sealant will squeeze

out from between drain and shower base floor creating an air tight seal.

· Flip shower pan upside down: Add rubber ring then cardboard ring and lastly screw on the plastic ring.

· While holding the bottom of the shower drain in place with split-joint pliers, use shower wrench to

tighten the plastic ring until drain sits flush with the shower base floor.

· Use rubbing alcohol and a towel to remove all excess silicone/plumbers putty from around drain lip.

4. Install Shower Base

· Re-insert shower pan into shower cavity making sure that the shower base drain and floor

rough-in are aligned.

· Before laying down shower base, fill shower cavity with expanding foam in snake formation.

Leave 6-8 inches from end of shower area empty if expanding foam.

· Re-insert shower pan into shower cavity leaving 1/8” (use shims) between wood studs and shower

base on all sides.

· Verify shower base is level using level tool on all 4 sides.

NOTE: Expanding foam generally settles within 10-15 minutes.

· Place drop cloth in bathtub and stand inside the shower base to press it to the floor when securing

to the wall studs.

SHOWER BASE INSTALLATION INSTRUCTIONS

Level

Side Flange

Top Flange

Wall Studs

1/8” gap

Square

Shim