Back-to-Wall Carrier System ® INSTALLATION INSTRUCTIONS well made forever Commercial Concealed In-Wall Toilet Tank for Back-to-Wall Toilet SM-WC326 @SwissMadison #WellMadeForever www.swissmadison.com | 1-434-623-4766 | info@swissmadison.
BACK-TO-WALL CARRIER SYSTEM INSTALLATION INSTRUCTIONS PRIOR TO INSTALLATION: · Inspect carrier to ensure no damages have occurred while in shipping. · Observe all plumbing and building codes in accordance with your state and local requirements. · All dimensions are nominal! Be sure to measure your toilet prior to installation. · The step-by-step guidelines in the installation instructions are a general reference. Should there be any discrepancies, Swiss Madison cannot be held liable.
BACK-TO-WALL CARRIER SYSTEM INSTALLATION INSTRUCTIONS Parts for Reference: 4 7 6 18 8 3 9 19 20 21 5 2 10 11 12 22 24 25 1 23 13 14 15 16 17 26 27 32 28 1.
BACK-TO-WALL CARRIER SYSTEM INSTALLATION INSTRUCTIONS 2. 3. 39 ³⁄8” 1 1 · Pay close attention to the 39 3/8” measurement (height from your finished floor). · Unit may be easily installed in wood framing (2” x 6” wall) frame accordingly and fasten securely. 39 ³⁄8” 0 ²³⁄64 ²5⁄64 x 2 ²³⁄64 ²5⁄64 x 2 2 2 3 3 · 39 3/8” is the center height from the finished floor to the mark indicated. 4. A B A B · Make sure unit is plumbed vertically and horizontally.
BACK-TO-WALL CARRIER SYSTEM INSTALLATION INSTRUCTIONS 5. 2 39 ³⁄8” L (max.¹5⁄64”) · From finished floor to mark indicated. · Refer to bowl being used to measure the correct heights and measurements (see below). 1 L=X-H 3 H X · De-burr any particles from pipe after cutting. 0 6. 1 2 Grease 3 · Lubricate with grease before installing. · Insert dirt cap (3) during construction.
BACK-TO-WALL CARRIER SYSTEM INSTALLATION INSTRUCTIONS 7. 1 2 3 4 · Remove cover plate to install water supply valve. 8. · Teflon tape is recommended on valve threads. Attach to waste supply valve and tighten carefully (see below). 1 3 2 1 2 · Install into tank and secure.
BACK-TO-WALL CARRIER SYSTEM INSTALLATION INSTRUCTIONS 9. 1 · Flush out water supply line before connecting to tank supply. Connect and tighten. 2 3 · Remember to turn the valve on once the installation is complete. 10. · You will hear a “click” when installed properly.
BACK-TO-WALL CARRIER SYSTEM 11. INSTALLATION INSTRUCTIONS 12. · Carefully cut off excess after complete installation. ²5⁄32” ~ 2 ³⁄4” max. ¹⁄8” max. ¹⁄8” Toilet Installation L L+¹5⁄64” · Insert tube into wall and mark as shown. · Insert tube into bowl and mark as shown. · De-burr any particles after cutting. · Lubricate both ends then install. — 7 — · Carefully measure between your marks, this distance will be cut off the bald end.
® well made forever ONE YEAR LIMITED WARRANTY 1-434-MADISON (623-4766) www.swissmadison.com Swiss Madison® products are made with quality materials and excellent craftsmanship to provide our customers with beautiful, durable, long-lasting products.