Full Product Manual

— 3 —
BACK-TO-WALL TOILET INSTALLATION INSTRUCTIONS
5. Fit and Level Bowl
· Place the bowl facing the flush pipe and waste
pipe, then push firmly until it touches the wall to
ensure that both pipes are in the correct position
and the correct length.
· Make sure bowl is level then mark on both sides of
the bowl where the anchors will be installed.
7. Install and Secure Toilet
· Make sure the pipes fit in properly and the toilet is
making contact with the floor and the wall surface.
· Once the toilet is placed properly, tighten the bolts
to secure the toilet.
8. Seal Edges
· Apply a thin layer of silicone sealant around the
perimeter of the toilet bowl. The use of an anti-mold
silicone is recommended. Remove any excess
silicone with a paper towel.
6. Install Anchors and Brackets
· Remove the toilet bowl and measure the thickness
of the bowl. Then apply that measurement in
towards the center from the marks on the floor.
· Insert anchors and install brackets.
Thickness of the
toilet bowl
measurement
Edge of toilet
marking
Anchors