Back-to-Wall Toilet INSTALLATION INSTRUCTIONS Swiss Madison @SwissMadison #WellMadeForever www.swissmadison.com | 1-434-623-4766 | info@swissmadison.
BACK-TO-WALL TOILET INSTALLATION INSTRUCTIONS PRIOR TO INSTALLATION: · Inspect toilet to ensure no damages have occurred while in shipping. · Observe all plumbing and building codes in accordance with your state and local requirements. · All dimensions are nominal! Be sure to measure your toilet prior to installation. · The step-by-step guidelines in the installation instructions are a general reference. Should there be any discrepancies, Swiss Madison cannot be held liable.
BACK-TO-WALL TOILET INSTALLATION INSTRUCTIONS 1. Install Tank 2. Dry Fit Flange and Inlet Pipe 3. Cut Pipes 4. Connect Pipes · Before toilet bowl installation, a wood frame and commercial or residential tank system is required. · Install according to manufactuer’s instructions. · Remove pipes from the bowl and measure the space between the marks on the pipes. · Carry this measurement over to the end of the pipes, adding 3/16” and then cut off the end of the pipes.
BACK-TO-WALL TOILET INSTALLATION INSTRUCTIONS 5. Fit and Level Bowl · Place the bowl facing the flush pipe and waste pipe, then push firmly until it touches the wall to ensure that both pipes are in the correct position and the correct length. · Make sure bowl is level then mark on both sides of the bowl where the anchors will be installed. 6. Install Anchors and Brackets · Remove the toilet bowl and measure the thickness of the bowl.
BACK-TO-WALL TOILET INSTALLATION INSTRUCTIONS TOILET SEAT INSTALLATION 1. Dissassemble · Disassemble the cover cap and the hinge. 2. Construct Hinges · Insert screw and nut into the hole on the hinge. · Attach blind hole screw fixing to the bottom of screw. Pull or 3. Attach Hinges · Insert hinges with blind hole screw fixings attached into holes on toilet bowl. · Lightly tighten hinges with a screwdriver to allow for later adjustment. 4.
BACK-TO-WALL TOILET INSTALLATION INSTRUCTIONS 5. Adjust and Attach Seat · Align seat to the hinges then firmly tighten the hinges. · Attach seat to the secure hinges. · Adjust seat to align to the bowl. TOILET SEAT USAGE · To remove, push middle button until you hear a “click”, then pull straight up. · To re-install, align hinge posts with reference marks on seat, then push down until your hear a “click”.
Swiss Madison ® ONE YEAR LIMITED WARRANTY 1-434-MADISON (623-4766) 19 Stults Road Dayton, NJ 08810 www.swissmadison.com Swiss Madison® products are made with quality materials and excellent craftsmanship to provide our customers with beautiful, durable, long-lasting products.
