0.8 GPF One-Piece Toilet INSTALLATION INSTRUCTIONS Swiss Madison @SwissMadison #WellMadeForever www.swissmadison.com | 1-434-623-4766 | info@swissmadison.
ONE-PIECE TOILET INSTALLATION INSTRUCTIONS PRIOR TO INSTALLATION: · Inspect toilet to ensure no damages have occurred while in shipping. · Observe all plumbing and building codes in accordance with your state and local requirements. · All dimensions are nominal! Be sure to measure your toilet prior to installation. · The step-by-step guidelines in the installation instructions are a general reference. Should there be any discrepancies, Swiss Madison cannot be held liable.
ONE-PIECE TOILET INSTALLATION INSTRUCTIONS 1. Turn Off Water Supply 2. Rough-In the Toilet 3. Install Closet Bolts 4. Install Wax Seal · Close toilet supply valve and flush tank completely, use towel to remove excess water. · Disconnect and remove supply line, if you are replacing the valve shut main water supply first. · Remove closet bolts from flange and clean wax and putty from base area. · Measure the wall from behind the toilet to the middle of the closet bolt.
ONE-PIECE TOILET TROUBLESHOOTING TROUBLESHOOTING PROBLEM CAUSE Slow or weak flush Fill valve not shutting off SOLUTION Water supply is blocked. Shut off, disconnect and check water supply valve. Low tank water level. Turn adjustment screw on fill valve clockwise to raise water level. Water supply valve is partially closed. Fully open water supply valve. Trapway or drain is partially clogged. Clear with a plunger, if you are unable to unclog, contact a plumber. Outlet is blocked by wax gasket.
ONE-PIECE TOILET INSTALLATION INSTRUCTIONS TOILET SEAT INSTALLATION 2. Construct Hinges 1. Dissassemble · Insert screw and nut into the hole on the hinge. · Attach blind hole screw fixing to the bottom of screw. · Disassemble the cover cap and the hinge. Pull or 3. Attach Hinges · Insert hinges with blind hole screw fixings attached into holes on toilet bowl. · Lightly tighten hinges with a screwdriver too allow for later adjustment. 4.
ONE-PIECE TOILET INSTALLATION INSTRUCTIONS 5. Adjust and Attach Seat · Align seat to the hinges then firmly tighten the hinges. · Attach seat to the secure hinges. · Adjust seat to align to the bowl. TOILET SEAT USAGE · To remove, push middle button until you hear a “click”, then pull straight up. · To re-install, align hinge posts with reference marks on seat, then push down until your hear a “click”.
Swiss Madison ONE YEAR LIMITED WARRANTY ® 1-434-MADISON (623-4766) 19 Stults Road Dayton, NJ 08810 www.swissmadison.com Swiss Madison® products are made with quality materials and excellent craftsmanship to provide our customers with beautiful, durable, long-lasting products.