Two-Piece Toilet INSTALLATION INSTRUCTIONS Swiss Madison @SwissMadison #WellMadeForever www.swissmadison.com | 1-434-623-4766 | info@swissmadison.
TWO-PIECE TOILET INSTALLATION INSTRUCTIONS PRIOR TO INSTALLATION: · Inspect toilet to ensure no damages have occurred while in shipping. · Observe all plumbing and building codes in accordance with your state and local requirements. · All dimensions are nominal! Be sure to measure your toilet prior to installation. · The step-by-step guidelines in the installation instructions are a general reference. Should there be any discrepancies, Swiss Madison cannot be held liable.
TWO-PIECE TOILET INSTALLATION INSTRUCTIONS 1. Turn Off Water Supply 2. Rough-In the Toilet 3. Install Closet Bolts 4. Install Wax Seal · Close toilet supply valve and flush tank completely, use towel to remove excess water. · Disconnect and remove supply line, if you are replacing the valve shut main water supply first. · Remove closet bolts from flange and clean wax and putty from base area. · Measure the wall from behind the toilet to the middle of the closet bolt.
TWO-PIECE TOILET INSTALLATION INSTRUCTIONS 7. Position Tank onto Bowl · Holes should line up so threaded rod can fit smoothly connecting the cistern body to the bowl. 8. Secure Tank to Bowl · Slide metal washer and rubber washer onto the bolt. · Thread bolts into the bottom of the tank then tighten the bolts using a screwdriver. · Do not overtighten, this may crack the ceramic. Metal Washer Rubber Washer 9.
TWO-PIECE TOILET INSTALLATION INSTRUCTIONS 11. Secure Tank 12. Connect Plumbing · Connect water supply. · Using screws and washers affix tank to wall. · Tighten to secure in place, do not over tighten. ³⁄8” Supply 13. Connect Push Button · Unscrew the big white nut on the push button and insert the button into the hole on the tank. · When the rods meet the push buttons, measure the height (H) with a ruler. · Unscrew the rods and cut the part H on both rods.
TWO-PIECE TOILET INSTALLATION INSTRUCTIONS TOILET SEAT INSTALLATION 1. Dissassemble 2. Construct Hinges · Disassemble the cover cap and the hinge. · Insert screw and nut into the hole on the hinge. · Attach blind hole screw fixing to the bottom of screw. Pull or 3. Attach Hinges · Insert hinges with blind hole screw fixings attached into holes on toilet bowl. · Lightly tighten hinges with a screwdriver too allow for later adjustment. 4.
TWO-PIECE TOILET INSTALLATION INSTRUCTIONS 5. Adjust and Attach Seat · Align seat to the hinges then firmly tighten the hinges. · Attach seat to the secure hinges. · Adjust seat to align to the bowl. TOILET SEAT USAGE · To remove, push middle button until you hear a “click”, then pull straight up. · To re-install, align hinge posts with reference marks on seat, then push down until your hear a “click”.
Swiss Madison ® ONE YEAR LIMITED WARRANTY 1-434-MADISON (623-4766) 19 Stults Road Dayton, NJ 08810 www.swissmadison.com Swiss Madison® products are made with quality materials and excellent craftsmanship to provide our customers with beautiful, durable, long-lasting products.
