Installation

Waterproof caulking around the base is recommended to
seal the bidet to the floor.
BIDET SUBLIME®
Model: SM-BD227
INSTALLATION INSTRUCTIONS
For a side by side toilet and bidet installation, it is
required to have a separation of 24”
(610mm)between units.
A trap is not supplied with the bidet. For installation of a trap
in the floor, provisions must be made.
Water supplies need to be at least 6” (152mm) to the left and
right of the bidet center line. Make sure to slip the chrome
trim plate on piping before attaching the supply stop valves.
Carefully set the bidet while making sure that the drain tube
is inserted into the waste pipe. After assuring the bidet has
been centered and is level, this connect should be sealed
either by compression or sweat connection.
Place the wood screws through the plastic snap-on bases
then through the screw holes at the base of the bidet. With a
screwdriver tighten the screws ½ turn.
(DO NOT
OVER-TIGHTEN
as you may break the foot of the bidet.
)
Finally, snap on the bolt caps.
Connect the hot/cold supplies to the hot/cold valve bodies
located on the bidet. Next, turn on the bidet and turn on the
water. Check for leaks. If needed tighten the compression
Share your pictures for a feature!
using #SwissMadison
www.swissmadison.com
1-434-MADISON
19 Stults Road, Dayton, NJ 08810
Swiss Madison
®