Installation

— 2 —
FARMHOUSE KITCHEN SINK INSTALLATION INSTRUCTIONS
1. Measure & Assemble Supports
· Measure actual height of the apron.
· Build support frames on the inside of cabinet
based on sink measurements.
3. Install Sink
· Carefully place sink into the opening. The
weight of sink should be sustained by the
pre-built support frames.
· Verify sink is leveled from side to side and
front to back using a level. Use shims, if
needed, to level sink.
· Use sealant to seal any gaps where required.
4. Install Countertop & Plumbing
· Use a bead of silicone or preferred adhesive
around the rim of the sink.
· Verify the alignment of the sink to the cutout
countertop. Align cut countertop hole over the
sink and press firmly.
· Connect drain trap to drain, and water supply
connections to the faucet according to
manufacturer’s instructions.
· Run water and check for leaks.
support
frames
2. Cut Front of Cabinet
· Measure the height of the front apron and add
1/16” to the dimensions when marking the cabi-
net front cutting location.
· Use saw to cut the cabinet.
NOTE: Always wear protective gear when using
dangerous materials.