Installation

To ensure base is installed correctly,
entire bottom support must contact
a flat, level surface
Bottom Support
Bottom Support
Wall
Square
3. Pre-Attach Drain
WARNING: Do not discard cardboard ring.
· Thread silicone or plumbers putty under drain lip, so when inserted excess sealant will squeeze
out from between drain and shower base floor creating an air tight seal.
· Remove shower base from dry fit.
· Flip shower pan upside down: Add rubber ring then cardboard ring and lastly screw on the plastic ring.
· While holding the bottom of the shower drain in place with split-joint pliers, use shower wrench to
tighten the plastic ring until drain sits flush with the shower base floor.
· Use rubbing alcohol and a towel to remove all excess silicone/plumbers putty from around drain lip.
7
B) Mark drain hole on floor. All in floor plumbing must be installed by a licensed plumber.
A) Verify that the shower base is level using the “level” tool on all four sides.
· If the shower base is level proceed to step B.
· If shower base is not level use shims or mortar compound to adjust accordingly. Verify with a level.
2. Level the Floor
SHOWER BASE INSTALLATION INSTRUCTIONS