SM WC426 Carrier Manual min

— 4 —
4. Fasten Mounts
· Tie your mechanical coupling into your existing sanitary line using a 4x3” or 3x3” depending on
your installation.
· Thread in threaded bolts, be sure the slotted end is to the outside for later adjustments. Place
plastic sleeves over the end of the bolts to protect during installation.
· Place dust covers as shown below.
— 6 —
5. Cut Drywall
· Install dry wall over carrier system in intended location.
· Find included cutout template. Cut out the small marked holes (1) to align cutout with the
threaded bolts.
· Align template up on your wall so the threaded bolts fit through the precut holes.
NOTE: Ensure cutout is plumb.
· Cut around the marked lines (2) to reveal the pipe/actuator locations behind the drywall.
WALL-HUNG CARRIER SYSTEM INSTALLATION INSTRUCTIONS