Specifications

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
FCC RF exposure statement:This equipment complies with FCC Radiation exposure
limits set forth for an uncontrolled environment. This equipment should be installed and
operated with a minimum distance of 20cm between the product and your body.
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy, and if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
FCC STATEMENT
CAUTION
Changes or modications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
7
• The charging cable is compatible with a qualied USB wall adapter.
• To ensure proper charging, use the enclosed USB charging cable.
• To use a qualied PD cable and PD wall adapter can enlarge the output and input
efficiency.
• Pull by plug rather than cable when disconnecting power bank to avoid damage to
electric plug and cable.
ELECTRICAL INFORMATION
SPECIFICATIONS
20000mAh
11000mAh
515g
40-inches
3 Modes: Spotlight - Flood light - Dual light
50 lumens/10m – 50 lumens/5m – 100 lumens/10m
Power bank Length
Power bank Width
Power bank Thickness
6.3-inches
3.4-inches
3-feet
1.2-inches
Rated Capacity
(Lithium-ion Battery)
Actual Capacity
Power bank Weight
Charging Cable
Flashlight modes
Brightness / beam
Impact Resistance
8
USB-C 5.0V 3.0A, 9.0V 2.0A, 12.0V 1.5A
Micro USB 5.0V 2.0A
Solar Panel 6.0V 0.22A
USB-C 5.0V 3.0A, 9.0V 2.0A, 12.0V 1.5A
5.0V 3.0A, 9.0V 2.0A, 12.0V 1.5A,
5.0V 4.5A, 4.5V 5.0A
USB-A2 5.0V 3.0A, 9.0V 2.0A, 12.0V 1.5A
TX Wireless 5.0V 1.0A(5.0W)
USB-C & USB-A
USB-C & TX(5W)
USB-A & TX(5W)
USB-C & USB-A & TX(5W)
INPUT
OUTPUT
5.0V 3.0A ( Max)
USB-A1
• Step 1:
A/B/C: Plug the cable (USB-C) to the power bank
D: Plug the cable (Micro USB) to the power bank
• Step 2:
A: Plug the cable (USB-C) to the computer or wall charger.
B/C/D: Plug the cable (USB-C) to the computer or wall charger.
• Step 3:
Digital indicator shows the actual power capacity by percentage, it ashes when
charging and stops when fully charged
A/B: Power bank fully charge time: 6 to 8 hours.
C/D: Power bank fully charge time: 9 to 11 hours.
KIND NOTE: all above is based on adaptor with a larger rated electric current!
- CHARGING THE POWER BANK BY SOLAR PAD
• Put the power bank in an open air with abundant sunlight (avoid high temperature) or
strong light environment
• Solar charging indicator light is green during charging
• Solar pad Input: 6V 0.22A
KIND NOTE: Solar charging effect will be subject to sunlight intensity and local
weather. It’s only recommended for EMERGENCY use, please DO NOT take it as
primary power resource. For daily use, please use qualied or provided charging cable
to charge the power bank.
OPERATING POWER BANK
9
A
B
C
D
Fast charging cable
Fast charging cable
Regular cable (included)
Regular cable
- CHARGING THE POWER BANK BY CABLE
- CHARGING OTHER DEVICES BY CABLE
• Step 1:
A: Plug the cable (USB-C) to the power bank
B/C/D/E: Plug the cable (USB-A) to the power bank USB A1/A2
• Step 2:
A/B/C: Plug the cable (USB-C) to the devices
D: Plug the cable (Micro USB) to the devices.
E: Plug the cable (Lightning) to the devices.
• Step 3:
Digital indicator shows the le actual power capacity by percentage.
A: Type C Output: 5.0V 3.0A, 9.0V 2.0A, 12.0V 1.5A
B/E: USB A1 Output: 5.0V 3.0A, 9.0V 2.0A, 12.0V 1.5A, 5.0V 4.5A,
4.5V 5.0A
USB A2 Output: 5.0V 3.0A, 9.0V 2.0A, 12.0V 1.5A
C/D: USB A1/A2 Output: 5.0V 2.0A
• Step 4:
Double press the Power & Mode Shi Button to stop charging.
- CHARGING DEVICES BY WIRELESS PAD
• Be sure the device to be charged is with wireless charging function
• Press the Power & Mode Shi Button to show the actual le power capacity and start
charging
• Put the device onto the power bank centered to match the wireless charging pad
• Wireless charging indicator light on the corner and the relative signal on digital
indicator screen are both blue when charging
• Indicator light ashes blue on the corner, and the relative signal on digital indicator
screen ashes red when the charging is with problem
A
B
C
D
E
Fast charging cable
Fast charging cable
(From or aer iphone 8)
Fast charging cable
Regular cable (included)
Regular cable
10
OPERATING THE FLASHLIGHT
• Press the power and mode shi button and hold 2 seconds to turn on the ashlight
• Press the power and mode shi button to shi modes among 3 modes: Spotlight - Flood
light - Dual light when the ashlight on
• Press the power and mode shi button and hold 2 seconds at any mode to turn off the
ashlight
If the power bank does not work, check the following:
• Fully charge the power bank before use.
• Ensure the cable is properly plugged into the power bank for charging.
• The battery may be depleted, allow the power bank to charge for at least 6-8 hours.
TROUBLESHOOTING
Be sure the device is matching to pad correctly
Be sure there is no metal stuff attached to the pad
Be sure the power bank is with enough capacity to do output, press the power and
mode shi button to active the digital indicator for check again.
• TX Wireless Output: 5.0V 1.0A (5.0W)
• Double press the Power & Mode Shi Button to stop charging.
• The phone may only be charged while it is laying on the table. Other use cases, such as
charging it while wearing it on the body/hold on hand, are not allowed.
11
NOTE:

Summary of content (2 pages)