Hardware Manual

Swiss Timing, Ltd. Version 1.1 Page 11 of 23
RTK_EQU_Tracking_System_Hardware-Manual.docx
Figure 8: Saddlecloth with EQTracker
Note: The LED on the EQTracker, which is inside the pocket of the saddlecloth, must point outwards.
Note: Make sure to do a function test of each device prior to the race day.
6.4 LED Status
The status LED on each EQTracker indicates its current operation mode. The possible devices statuses are set out
in the table below:
LED Status
Description
Illuminating red
Device is being charged in charging case
Illuminating green
Device is fully charged in charging case
Blinking green
Device is healthy and can be deployed
Blinking red
Device has issues and should not be deployed (if longer than 2 min after
taken from charging case)