User's Manual

2. Instructions for use
1) Add Swissdigital Design FMN Finder( the FMN device)
Place the FMN device next to the iOS device and press the button. When you hear
a beep, it means that the FMN device has been turned on normally. Open the "Find My"
APP on the iOS device, click the "Add Item" menu on the "Item", then click "Other
Supported Items" and finally enter the FMN name to complete the FMN device setting.
2) How to quit pairing broadcast
Use a coin to open the upper and lower shells and remove the battery.
3) Enable serial number view
Press the button and hold for 4 seconds to hear two beeps and lift up.
4) Restore factory configuration
Press the button and hold for 6 seconds to hear three beeps and lift up
5) Remove the FMN device
l Place the FMN device next to the iOS device, open the "Find My" APP, and click
"Device" to list the devices signed to the APPLE ID. Click the FMN device and
click "Remove this device" on Find Myapp to remove the FMN device.
l If the FMN device is be removed when it is not connected to the iPhone, the
hardware unpaired process is needed. Press the button and hear three beeps
and lift up, then the hardware is removed successfully.
6) Battery replacement
As shown in the figure below, use a coin to open the upper and lower shells, replace
a new CR2032 button battery, and buckle the upper and lower shells by hand to