User manual

4 Installation and starting up
Unpack and carefully check that there is no transportation damage before using the
unit. Keep the equipment packaging. To fully protect the device against vibration,
dust and moisture during transportation or storage use the original packaging or
your own packaging material suitable for transport or storage, respectively.
Create all connections while the device is off. Use the shortest possible high-quality
cables for all connections. Take care when running the cables to prevent tripping
hazards.
Power supply is enabled once you connect the unit through the USB port and the
included USB cable to a PC. If desired, connect a Sustain and / or an Expression pedal
to the device (pedals are not included). Turn on the device using the main switch on
the rear panel.
Start the DAW installed on your computer and adjust the software and MIDI settings.
System requirements:
n Windows XP/Vista/7®, at least 800 MHz, at least 256 MB RAM
n Mac OS X V.10.4.9® and higher, at least 733 MHz, at least 512 MB RAM
To operate the device with any MIDI device (such as a sound module) you need an
external 9V mains adapter for power supply (not included). In this case, connect your
device via the 5-pin MIDI output on the rear panel to the input of the MIDI device. If
desired, connect a Sustain and / or an Expression pedal to the device (pedals are not
included). Turn on the device using the main switch on the rear panel.
Operation with a computer
Operation with a MIDI device
Installation and starting up
MIDI keyboard
8