User manual

Tip: Some features require extra
memory, to expand your phone’s storage
capacity, install a micro SD card.
3. Micro-SD card (optional)
Lightly press the card
holder and push it
carefully toward the
corner of the
compartment. The
card holder can now be ipped up
vertically. Place the memory card in the
black plastic bracket. Make sure that
the memory card contacts are facing
down and that the card is placed in
accordance with the marked area (see
gure). Do not scratch or bend the card
contacts. Push the metal holder back
down, press it at and slide it until it
snaps into place.
1. Charging
contacts
2. Micro USB
port
For battery charger
3. + and - keys
Adjust ring volume
and
loudspeaker volume
4. LEDs
Blue = battery full
Blinking blue = Dur-
ing calls, Notication
of missed calls and
received SMS
5. LEDs
Red = Battery charg-
ing
6. Headset
socket
For 3.5 mm standard
headset
7. Torch key
8. Charging
cradle
9. Receiver/
loudspeaker
Make phone calls
holding the cell phone
to the ear
10. Display
11. Left soft key
Right soft key
Main menu
Phone book
12. Call key
Dial and answer calls;
open the call log
13. Arrow keys
In idle state to
open the quick access
list
to open Proles.
Scroll up and down in
menus and lists
14. Handsfree
key
Switch to handsfree
during a call
15. Alarm clock
shortcut
16. Numerical
keys
In idle state: input of
phone number;
long keystroke on 1:
calling the voice mail
box (the phone num-
ber must be stored)
17.
*
key
In idle state: to enter:
“*”/ “+” / “P”/“W“;
Input: special charac-
ters
18.
#
key
In idle state: long
keystroke to toggle
between ring tone on/
off;
Input: toggle input
modes
19. SMS shortcut
20. End key
End a call, return to
idle mode; switch the
phone on/off
21. SOS key
Install the SIM card and the battery
The SIM card holder is located inside the
battery compartment.
CAUTION
Only use batteries, charger and
accessories that have been approved for
use with this particular model. Connecting
other accessories may be dangerous and
may invalidate the phone’s type approval
and guarantee.
1. Remove the battery cover
slide your ngernail into the small
notch on the bottom
side of the phone
and pull the cover
upward. If the battery
is installed, slide
your ngernail in the
notch next to the battery to lift it up.
2. Insert the SIM card (required)
push it carefully in
under the metal
bracket on the lower
side. Make sure the
contacts of the SIM
card point
downwards and the cut-off corner ts
exactly in the recessed shaping of the
holder. The contacts of the SIM card
must not be scratched or bent. Try not
to touch the contacts with your ngers.
BBM 605
© IVS GmbH 2015 • All rights reserved
QSG_Swisstone BBM_605_en_A3(A7)_v1.0
English
Version 1.0
0359
Specications
Network:
GSM 900/1800 MHz
Dimensions:
92 mm x 44 mm x 16 mm
Weight:
76 g
Battery:
3.7V/800 mAh Li-ion
battery
Operating ambient
temperature:
Min: 0°C (32°F)
Max: 40°C (104°F)
Charging ambient
temperature:
Min: 0°C (32°F)
Max: 40°C (104°F)
Storage
temperature:
Min: -20°C (-4°F)
Max: 60°C (140°F)
Changes and errors excepted.
EN
1
2
3
4
5
6
9
10
11
12
13
14
15
16
17
18
19
20
21
7
8
IMPORTANT!
Use only compatible memory cards
with this device. Compatible card type:
microSD, microSDHC.
Incompatible cards may damage the
card itself, the device and corrupt any
data stored on the card. Depending on
the market some phones may have a
pre-installed memory card.
4. Insert the battery (required)
by pushing it into the
battery compartment
ensuring that the
three contacts on
the front touch the
three spring contacts on the bottom in
the battery compartment.
5. Replace the cover and push it upward
using gentle pressure with the thumb
until it snaps securely into place again.
When the battery performance is low, the
empty battery symbol ashes to indicate
the battery state and an alarm signal will
sound. To recharge the battery, connect the
mains adapter to the micro USB connector
on the bottom side of the phone.
Alternatively, you can place the telephone
into the charging cradle connected to the
main adapter via the USB cable.
During charging, the red charging LED
is on and the charge status icon moves
(visible in the upper right corner of the
display).
A complete charging process of the
rechargeable battery takes approximately 3
hours. When the battery is fully charged the
animation of the charge status icon stops.
Power on the phone
Press and hold the red key on the
phone to turn it on and off.
If the SIM card is valid but protected with a
PIN code (Personal Identication Number),
Enter PIN is displayed.
Enter the SIM PIN code and press OK
( upper left corner of keypad). Delete
with Delete ( upper right corner of
keypad).
Make a call
1. Enter the phone number with the area
code. You can delete digits with Delete .
2. Press to dial. Press Cancel to
cancel dialling.
3. Press to end the call.
Tip: For international calls, always enter
a + symbol before the country code to be
able to use the phonebook optimally in
any country.
Press the
*
key twice to enter the inter-
national area code +.
Answer a call
1. Press or Answer to accept the call
or press reject to reject the call (busy
signal).
Alternatively, you can press to
reject the call directly.
2. Press to end the call.
Create phonebook entry
1. Press Menu â Phonebook â OK .
2. Select Add new contact â Add .
3. Select whether you want to save the
contact on the SIM card or in the phone.
4. Enter a name for the contact.
5. Press .
6. Enter the phone number including the
area code.
7. Press .
8. You can select a different ring tone for
the contact by using the keys
*
and
#
.
Note! Storage needs to be set to Phone .
9. Then press Options â Save â Select .
Set language
The default language of the phone menu,
messages and so on is determined by the
SIM card used (Automatic). You can always
switch between the languages supported
by the phone.
1. Press Menu â Settings â OK .
2. Select Phone settings â OK .
3. Select Language â OK .
4. Select language â OK .
Set time and date
1. Press Menu â Settings â OK .
2. Select Phone settings â OK .
3. Select Time and date â OK .
4. Select Set time/date â OK .
5. Enter the time (HH:MM) â .
6. Enter the date (DD/MM/YYYY) â OK .
Tip: For international calls, always enter
a + symbol before the country code to be
able to use the phonebook optimally in
any country.
Press the
*
key twice to enter the inter-
national area code +.
Volume control
You can adjust the volume during a call
using the side keys + / – . The volume level is
shown on the display.
Enter text
Select character
• Press a numerical key repeatedly
until the desired character is shown.
• Wait a few seconds (until the blue
background of the character has
disappeared) before entering the
next character.
Special characters/smileys
• Press
*
to view a list of special
characters.
• Select the desired character with or
*
and
#
(to move left or right) and
press OK to enter.
Move the cursor within text
• Use the keys / , to move the
cursor within the text.
Upper case, lower case and numerals
• Press
#
to choose between upper
case, lower case and numerals. The
symbol at the top left in the display
indicates the input mode.
Instructions