User manual

ePure TAM 2nd generation
14 ePure TAM 2nd generation
Extending number of handsets
The delivered handset is already registered on to base station. In
standby the internal number of the handset is displayed.
You can register up to 4 handsets to your base station.
If you register your ePure handset with a “third party” base station
or a “third party” handset on your ePure base station (GAP), you
may not be able to use some functions or only to a limited extent.
Register new handsets
Registering an additional handset with the main base station (the
base station you have connected to the telephone network):
● Press and hold down the Paging key on top of the base
station for at least 10 seconds.
● Press the menu key.
● Using the navigation key find Advanced Set and press OK.
● Scroll down until you find Register and press OK.
● After a few seconds you will be asked to enter your PIN.
● Enter the PIN (default 0000) and press OK.
● If the registration is successful you will see the handset
number on the screen.
Press the talk key (as if you wanted to make a call) to make sure
a dial tone is available.
Repeat this procedure for every additional handset you wish to
add to your ePure TAM phone.
If the registration is not successful:
● Move closer to the base station. During registration the
distance between handset and base must be less than
1 m.
● Interrupt power supply of base and handset (disconnect
power adapter/remove battery).
● Repeat the registration procedure.