User manual

ePure TAM 2nd generation 23
ePure TAM 2nd generation
● Make sure that the handset is registered to the base, see
chapter “Registering an additional handset”.
● Check that the mains power is connected properly and
switched on.
Keypad does not seem to work
● Check that the keypad lock is not on.
icon is not fully charing the battery in operation
● Adjust the handset slightly on the base.
● Clean the charging contacts with a cloth moistened with
alcohol.
● Check that the mains power is connected properly and
switched on.
● The battery is full. When the handset is fully charged,
icon is steady on.
No Caller ID
● Check your subscription with your network operator.
● The caller may have withheld their number.
● The record cannot be found in your phonebook. Check that
you havew the correct name / number stored in your
phonebook, with the full area code.
I have forgotten my PIN!
You can reset your handset back to default setting from
Advanced settings, then the handset will automatically reset and
the PIN will default back to 0000.
Cannot register a handset to the base
● You can register up to a maximum of 4 handsets to a ePure
base. You must de-register a handset in order to register a
new one.
● Check that you have entered the correct PIN code
(default = 0000).
● Check that you are at least one meter away from other
electrical equipment to avoid interference when registering.
Handset does not ring
● The handset ringer volume may be set to Off.