Operation Manual

• Wait for about 2 s. When the connection is established, the volume
LEDs on the parent unit flash briefly.
• Place the baby unit in the baby room about 2 meters away
from the baby.
• Use the volume control on the parent unit to set the desired
volume. The volume LEDs indicate the set volume.
• If the baby unit does not detect any sounds in the surroundings,
the transmitter is switched off; the parent unit is then in standby
mode (VOX). When the baby unit perceives noises again, the
transmitter is switched on again and the transmission to the parent
unit starts.
Note:
If you notice any noise or interference during the transmission, you
can change the channel. During operation, briefly press the pairing
button in the battery compartment of the baby unit with a pointed
object (eg straightened paper clip). The devices try to find a
trouble-free channel and continue operation.
Pairing
When delivered, the devices are already radio-linked (pairing). If this
connection is lost at some point, which is very rare, you can do this
pairing yourself as follows:
• Turn off both devices.
• Simultaneously press and hold the pairing button in the battery
compartment of the parent and baby unit with a pointed object
(such as a straightened paper clip).
• Turn on both devices.
• Release the pairing buttons after 1 second.
• If the volume LEDs on the parent unit flash briefly, the pairing was
successful and the connection is established again.
9