Operation Manual

26

 If you do not intend to use the units for a longer period of
time, remove all the batteries.
Otherwise, they could leak.
 It is recommended to use the 9 V power adapter plugs for
both units.
 If both units are equipped with batteries and the adapter plugs
are inserted to both, the units only operate via the batteries
following a power failure when the adapter plugs are
disconnected from the transmitter and receiver units.
7 Operation
1. Transmitter unit
 Ensure that the power adapter plug is connected or the battery
has been inserted properly.
 Position the transmitter unit near the baby and ensure that the
microphone is pointing towards the baby to enable optimum
transmission. (Fig. III)
 Ensure that the unit is out of reach of the baby. Never place
the unit in the baby’s bed or playpen!
 When the microphone integrated in the transmitter unit detects
noises (range 1 to 2 m), it automatically starts to transmit signals
to the receiver unit. When no further noise is detected,
transmission is stopped.
2. Receiver unit
 Ensure that the power adapter plug is connected or the battery
has been inserted properly.
 Place the receiver unit near the supervising adults (Fig. III).
 Move the loudspeaker control to the required setting.
 If a sound signal is sent by the transmitter unit, the receiver is
activated and transmits the sounds received.
 A few seconds after the device has no longer received acoustic
signals, the receiver automatically switches back to energy save
mode.