Operation Manual

Night Light Setting
1. When you enable the auto mode , the icon will light up. You can
choose the sensitivity level. With the level set to high, the light sensor will
detect dimmer light. See Fig. 19.
2. When the light from the camera reaches the set level, the night light will
turn on as setting.
3. When you enable the manual mode , you can turn ON/OFF the night
light as setting.
4. Press the icon , you can change the color of night light. There are
three colors of night light (yellow, green, orange).
5. Press the icon , you can change the level of brightness. There are four
levels of brightness.
Display Frequency and White Balance Setting
1. In this submenu you can choose what frequency and color temperature are
better on the monitor. See Fig. 20.
2. There are three types of color temperature and two frequencies (50Hz or
60Hz).
Delete Camera
In this submenu you can delete a paired camera.
1. Please press which number of cameras you want to delete. See Fig. 21.
2. Press to delete.
Add Camera
The system comes with a camera unit that has already been paired with the
monitor unit. The pairing function gives each camera unit a separate channel on
the monitor unit. This is necessary for configuring additional camera units.
1. In this submenu you can add a new camera. See Fig. 22.
2. Please choose which number of cameras you want to add, and then press
the icon .
3. The monitor will wait for pairing and then please also press the pairing button
over three seconds on camera side. You don’t need to turn on the power of
camera.
4. Pairing is completed, it will show " “ on the monitor.
5. Pairing is failed, it will show the picture on the monitor. See Fig. 24.
6
3.11
3.10
3.9
3.8
2.4 '' Touch-Screen
Wireless Video Baby Monitor