Operation Manual

GB
65
Starting Up
2 Starting Up
Safety note
Check the contents of the package
The package contains:
Content DC601 DC602 DC603 DC604
1111tinu esaB
Charger unit 0 1 2 3
Cordless handset 1 2 3 4
Battery cover 1 2 3 4
Power adapter plug 1 2 3 4
Telephone connection cable 1 1 1 1
AAA 1.2V 800mAh NiMH
rechargeable batteries
2468
Operating manual 1 1 1 1
Connecting the base unit
Connect the base station as illustrated in the diagram.
For reasons of safety, only use the power adaptor plug and telephone
connection cable supplied.
4HPUZWV^LYV\[SL[
9LJLP]LYJVUULJ[PVU
Inserting the batteries
Insert the 2 x AAA 1.2V 800mAh NiMH rechargeable batteries supplied,
into the handset battery compartment. Take care to note the ‘+’ and ‘-’
markings and position the batteries the correct way around. Close the
battery compartment cover.
Charging the batteries
Place the handset in the base to charge for a minimum of 15
hours before fi rst use.
Private branch exchanges
The information on Page 77 explains how to install your
telephone on a private branch exchange.
Low-radiation operation (ECO mode)
In Standby mode, the radiation is reduced considerably as compared to
Electrical consumption
The electrical consumption of the base is:
- in operation mode (idle/call): approx. 0.87 W/1.36 W
- during charging of the handset: approx. 2.15 W.
The adaptor input power without load is approx. 0.20 W.
The average efficiency is approx. 67.3 %.
The electrical consumption of the charger is:
- without handset charging: approx. 0.32 W
- during charging of the handset: approx. 1.7 W.
The adaptor input power without load is approx. 0.32 W.
The average efficiency is approx. 44 %.
standard, cordless DECT telephones when the handset is on the cradle.
Caution: It is essential to read the Safety Information in
Chapter 1 before preparing the telephone for use.