Operation Manual

106
corded for both operating modes. This means that the answering machine
is immediately ready for use. If Answer and record" mode is active and
you reach the end of the maximum recording capacity, the machine auto-
matically switches to Answer only" mode.
If the answering machine is switched off, the the outgoing message for
Answer only" mode is played after approx. 10 rings.
The corresponding icon in the handset display indicates whether the
answering machine is switched on or not.
The date and time of recording of the message are indicated in the display
when playing the messages on the handset. A condition for this is that the
date and time have been set correctly (menu option:
HS SETTINGS > DATE & TIME). * HIGH > approx.15 minutes, MEDIUM > ap-
prox. 9.5 minutes, LOW > approx. 7 minutes
The following information appears on the base station display according to
the operating status:
− − Dashes on: The answering machine is off.
Dashes flash: The answering machine is on, the time
has not been set.
XX Digits on: The number of old messages.
Digits flash: The number of new messages.
LA Flashing: Access is being made to the answering
machine from a handset or via remote access/control.
A1/A2 Outgoing message is being played (A1=Answer and
record / A2 =Answer only)
FF Flashing: The answering machine memory is fully.
Lx When setting the answering machine volume on the
base station: x=indicates the current volume setting.
New messages are indicated in the handset display by
the s icon when being played.
Operating options on the base station
The operating elements on the base station enable you to switch the
answering machine on/off, play and delete messages. The date and time
the message was recorded are only displayed in the handset display in the
case of remote access.
 Switch the answering machine on/off
 Set the volume for message playback.
q s Start/Stop playback.
 Delete message.
 Skip to next message / previous message.