Operation Manual
Answering Machine
48
Delay before taking a call
You can select between Immediately", 10", 20" and 30" seconds or the Toll-saver"
setting for pre−remote access. The toll−saving, pre−remote access feature can be used to
check whether new messages have been recorded on your answering machine from a
distant telephone.
If new messages have been recorded on your answering machine, your call is
taken after 10 seconds.
If no messages have been recorded, the call is taken after 30 seconds. Replace the
receiver after 10 seconds have elapsed. No charges ensue for the call.
Open the main menu
or
AM Operation , Select the menu and confirm
or
AM Setting , Select the submenu and confirm
or Ring Delay , Select the function and confirm
or e.g:
Immediately
, Select the delay required and confirm
Further information on remote access Page 51
Alert signal for recorded messages
If a new message/memo has been recorded, an acoustic signal is issued every 15 se-
conds.
Open the main menu
or
AM Operation
, Select the menu and confirm
or
AM Setting , Select the submenu and confirm
or
Msg. Alert
, Select the function and confirm
or
Off
or
On
, Switch the alert signal on/off
Call screening
You can listen−in to the caller without actually taking the call.
Open the main menu
or
AM Operation
, Select the menu and confirm
or AM Setting , Select the submenu and confirm
or
Call Screen
, Select the function and confirm
or
Off
or
On
, Switch call screening on/off
Taking a call being recorded
It is possible to take a call even if the answering machine has already begun to take it.
Recording of the message is stopped in this case.
or Take the call