Operation Manual
46
47
Special Functions
60
9 Special Functions
Automatic answering
If this function is activated, an incoming call is taken when the handset is removed from
the base station. Page 55
Dialling mode
The telephone can be operated in new, digital exchanges (TONE) as well as analogue
exchanges (PULSE). Page 56
Temporary tone dialling
If you only operate the telephone using the PULSE dialling mode, you can still make use
of the advantages of TONE dialling mode (e.g.: remote access of the answering ma-
chine in the conventional telephone network). You can temporarily switch to Tone dial-
ling when a connection has already been made.
3 sec Press the button during a call
When the call is ended, the equipment automatically switches back to Pulse dialling.
Room monitoring
This function can be used when two DCT507 handsets are available for use.
Use the Room Monitor" submenu to dial a second handset and place the handset in the
room to be monitored. Take the call on the second handset. You can then monitor the
room as long as the connection remains established.
Walkie−Talkie
This function can be used when two DCT507 handsets (HS 1, HS 2, ...) are available for
use.
The function must be activated on all the handsets participating in the facility,
Page 56. When this function is activated, the handsets operate independent of the
base station. No external calls can be made or taken by the handsets when this function
is being used.
E.g.: HS 1: Call the handset
E.g.: HS 2: Take the call
HS 1/HS 2: End the call
Prefix dialling
This function enables a specified number to be dialled automatically prior to the actual
phone number. This is mainly implemented when using call−by−call numbers.
A call−by−call prefix with up to 24 digits can be stored. The call−by−call number is auto-
matically prefixed and is not displayed in addition to the selected phone number.
If you press the Call button first to obtain a dialling tone and then enter the phone num-
ber, the call−by−call number stored is also prefixed.