Operation Manual

11
Operation
Hearing damage due to high volumes! This receiver allows you to set higher
volumes than conventional headphones. This can cause hearing damage in
persons with healthy hearing and especially in children.
• Before putting the receiver on, set the volume on the receiver to a low value.
• Do not continuously expose yourself to high volumes.
1 Switch on the audio source. The green indicator LED on the transmitter lights up
constantly.
2 Switch the On/Off switch on the headset receiver to ON position, then the blue LED
indicator lights up constantly. The transmitter and the headset receiver will then be
connected automatically.
3 Flex the head set arms outwards until the ear buds can be inserted in the ear.
Please note the ear buds can be angled through a movement up, down or sideways,
so as to enter the ear a little deeper. This will improve the sound quality and volume.
Gently press the ear buds further into the ear to find a comfortable position for the
ear buds and an ideal position for the sound.
4 Adjust the desired volume.
5 Adjust the balance (left/right) if neccessary.
Note: When the battery level is low, the indicator LED sparkles in blue.
You will hear 3 beeps every minute and 1 double-beep in the forth minute. The
receiver will switch off automatically in the fifth minute.
• A fully charged battery provides up to 5 hours of listening enjoyment.
• To conserve battery power, the receiver automatically shuts off if no signal is
detected for a period of approx. 5 minutes or when the level is too low.
The microphone button
The microphone opening at the lower part of the receiver front picks up the sounds of
your surroundings. When the microphone is switched on, you will hear your surroundings
louder. You can hear for example your door bell, your telephone or your conversational
partner even when you are wearing the receiver.
Press the microphone button to switch the microphone on. The power on indicator will
turn to green and two short beeps are to be heard. Make sure that the microphone
opening is not covered!
You can hear your surroundings and you use the receiver as an assistive listening device
which helps you to better hear other people.
Press the microphone button again to switch off the microphone. The power on indicator
will return to blue and two short beeps are to be heard.
Caution: When switching between the microphone and music source please be aware
that the volume level can change substantially dependant upon signal input levels. As a
precaution the volume level should be lowered prior to switching between the
microphone and music.