MANUAL-COMBO-VIA User Manual IEEE 1394A + USB 2.
About this card This VIA IEEE 1394A + USB 2.0 Combo card is design to offer a cost effective and reliability solution to the users with PC’s that have no integrated IEEE 1394A and USB 2.0 support. The IEEE 1394A ports uses the most advanced, high-speed digital technology, low-cost and high bandwidth isochronous (real-time) data interfacing between computers, computers peripherals and consumer electronics products such as camcorders, VCRs, printers, TVs and digital cameras.
• • • • • • Compliant with IEEE 1394 Standard for High Performance Serial Bus and P1394A Supplement 4.0 Each 1394A fully compliant cable port supporting 100/200/400 Mbit/sec 2 External ports and 1 internal port (Shared) Compliant with PCI Bus Power Management Specification V1.1 Full support of real time dynamic insertion and removal of devices Fully supported by Microsoft Windows 98, 98SE, ME, 2000, XP and MacOS 9.0 Operating System USB 2.
What is in your package? You should have the following items in your package; • One VIA IEEE 1394A + USB 2.0 Combo card • One User Manual • One Driver Installation CD Optional Accessories • Ulead Video Studio 5.0 • One IEEE 1394A cable Installing the VIA IEEE 1394A + USB 2.0 Combo card Installing this VIA IEEE 1394A + USB 2.0 Combo card to your computer is simple, just simply follow these steps. • Turn off your computer and all external devices connected to it.
For Windows 98/98SE/ME/2000 & XP Operating System Note: Make sure you have your Microsoft Windows O/S Installation CD ready before installing this IEEE 1394A + USB 2.0 Combo card. 1. Installing 1394 Bus Controller driver This combo card is compliant to IEEE 1394 OpenHCI Specifications and compatible with Microsoft OHCI, DV and SBP-2 driver in Windows 98, Windows 98SE, Windows ME, Windows 2000 and Windows XP operating system.
If you have decided to use the Microsoft EHCI driver, you need to download Windows XP service Pack1 for the Microsoft EHCI drivers. Please refer to “To download Windows XP Service Pack 1” on how to download the driver. If you have already installed Windows XP Service Pack 1 in your system, Windows XP will automatically install the drivers for you. If you have decided to install the VIA EHCI driver we provided with the combo card, please refer to “Installing Windows XP/2000/ME/98SE/98 driver”.
a) Three “VIA PCI to USB Open Host Controller” devices – Full driver support by Microsoft OpenHCI based drivers, no additional driver required. Simply follow the Windows instructions to install the Microsoft ALi Open Host Controller driver. b) Windows should also detect a “PCI Universal Serial Bus” device prompt you for the driver. Please click the “Cancel” button to end installation. 2. Insert the supplied Driver Installation CD into the CDROM drive. 3.
VIA Rev 5 or later Host Controller USB 2.0 Root Hub USB Root Hub USB Root Hub USB Root Hub If there is no yellow exclamation mark next to any of the above items then you have successfully installed the drives for the VIA IEEE 1394A + USB 2.0 Combo card. Notice: If you can't setup driver successfully, please reboot your system and then follow above steps to install driver again.
