User manual

SY-KVM31036 10
Hub Selection (Hot key Switch for USB Hub Selection)
If the Hub Auto-Switch function is disabled, the USB hub switch is independent
from the host port. You can use the following hotkeys to switch the USB hub to a
specific port:
[Scroll Lock] + [Scroll Lock] + [Q]: Switch USB hub to port 1
[Scroll Lock] + [Scroll Lock] + [W]: Switch USB hub to port 2
[Scroll Lock] + [Scroll Lock] + [E]: Switch USB hub to port 3
After the HUB Auto-Switch function is enabled the USB hub will be switched
along with the host port selection by hotkey.
In this mode, the kotkey: [Scroll Lock] + [Scroll Lock] + [Q/W/E] for HUB
switching is disabled.
[Scroll Lock] + [Scroll Lock] + [1]: Switch both host and hub to port 1
[Scroll Lock] + [Scroll Lock] + [2]: Switch both host and hub to port 2
[Scroll Lock] + [Scroll Lock] + [3]: Switch both host and hub to port 3
Hub Selection (Hub Selected indicator)
The Hub Selected LED (Green LED) on the KVM front panel indicates the USB
hub selection status:
On: Indicates the USB hub is active at this port.
Off: Indicates the USB hub is not active at this port.