User manual

SY-KVM31036 9
Host Selection (Host Selected Indicator)
The host selected LED (Red) on the KVM front panel indicates the host port
status:
- On: Indicates the host port is available and selected.
- Off: Indicates the host port is not selected.
- Flash: Indicates the host port is selected but is not available.
Hub Selection
Hub Selection (USB Hub Switch by Push Button)
You must enable the Hub Auto-switch function before you can use the push button
switch. There are two ways to toggle the Hub Auto-Switch alternatively:
- Press any button on the KVM front panel for 3 seconds.
- By using hotkey: [Scroll Lock] + [Scroll Lock] + [H]
After the Hub Auto-Switch function is enabled, the hub auto-switch / auto-scan
indicator on the front panel will turn ON statically and, the USB hub can be
switched along with the selected host port by using the push button on the front
panel. The USB hub switching time is one second later after the port switch, the
reason the switch is delayed is to decrease the USB enumeration loading if the user
changes active ports quickly.